Sauder L-Shaped Desk Manual Del Usuario página 7

Step 2
Separate the EXTENSION SLIDES (GG) from the
å
EXTENSION RAILS (FF) as shown in the enlarged
diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (FF) to the RIGHT END (A)
å
and RIGHT UPRIGHT (C). Use four GOLD 5/16" FLAT
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END and UPRIGHT. Turn
a SCREW into this hole.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
C
Open end
Notched edge
www.sauder.com/services
GG
Push the black lever in and pull the SLIDE from the RAIL.
3S
FF
FF
Notched edge
A
418270
Remember:
Righty tighty.
Lefty loosey.
Open end
FF
Page 7