Gold 5/16" Flat Head Screw - Sauder L-Shaped Desk Manual Del Usuario

Step 22
Fasten the EXTENSION BLOCK (X) to the LEFT UPRIGHT (D). Use two
å
SILVER 1-1/8"FLAT HEAD SCREWS (10S) through the larger holes in the
EXTENSION BLOCK.
Fasten the DRAWER UPRIGHT (W) to the CONNECTOR PLATE on the
å
SMALL TOP (F). Tighten two HIDDEN CAMS.
NOTE: Use the two large holes closest to the LEFT UPRIGHT (D) in the
å
CONNECTOR PLATE.
Then, fasten the DRAWER UPRIGHT (W) to the MODESTY PANEL (H). Use a
å
METAL BRACKET (4G) and two BLACK 9/16" LARGE HEAD SCREWS (1S).
Now, fasten a CABINET RIGHT (35GA) to the DRAWER UPRIGHT (W) and
å
a CABINET LEFT (35GB) to the EXTENSION BLOCK (X). Use four GOLD
5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
Continue with Step 24 now.
å
10S
SILVER 1-1/8" FLAT HEAD SCREW
(2 used for the EXTENSION BLOCK)
www.sauder.com/services
H
F
W
S u r
f a c e
H I D
D E N
3
2
2
1
D
X
Finished
edge
4G
w i t h
C A M
S
1
Roller end
Finished
edge

GOLD 5/16" FLAT HEAD SCREW

(4 used in this step)
418270
PENCIL DRAWER ON LEFT
Maximum
Arrow
210 degrees
Minimum
190 degrees
BLACK 9/16" LARGE HEAD SCREW
(2 used for the METAL BRACKET)
3S
1S
Page 27