ABB FM/E 1.1 Instrucciones De Montaje Y Servicio página 18

Installation
Set the required address code using the slide
switch. For assembly purposes, unscrew the
Home Smoke Detector from the base and plug
the 5-pin multiway connector of the radio
module into the relevant plug socket of the
Home Smoke Detector. Screw the Home
Smoke Detector into the base again. Test the
radio circuit by pressing the test button.
In order to connect the radio module to the
contact module, connect the leads to the
screw terminals, pierce a hole in the perfora-
tion on the base and feed the leads through.
®
When connecting to an ABB i-bus EIB, it is
advisable to use the Zone Terminal* from ABB.
* See ABB Product Catalogue