Cequent Performance Products 24936 Instrucciones De Instalación página 4

1. Bottom panel removal – use 10 mm socket and screwdriver to remove (3) bolts
and (6) plastic rivets, see Figure 2.
3. Bumper beam removal – unplug wiring at the bottom of bumper beam each
side. Use 8 and 13 mm socket to remove flange nut and screw attaching to
exhaust hanger and splash guard, see Figure 4. Use 19mm socket to remove (4)
flange nuts attaching to bumper end panel and then remove bumper beam, see
Figure 5.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Fascia removal – open the trunk and remove cover panel between tail light and
rubber seal. Use 8 mm socket to remove (1) bolt near tail light and (3) bolts near
wheel well each side, see Figure 3. Gently remove the fascia and unplug wiring. Set
bumper fascia aside.
4. Hitch installation – raise the hitch and align the slots on hitch with studs on the
end panel. Raise the bumper beam and sandwich the hitch, see Figure 1. Reuse the
flange nuts and loosely fasten them.
Sheet 4 of 15 24936NP 11-04-15 Rev. B