Dash Disassembly; Kit Assembly - Metra 99-8159S Instrucciones De Instalación

Dash Disassembly

1. Unsnap and remove shifter trim.
(Figure A)
2. Unsnap and remove power outlet
panel below radio. (Figure B)
3. Remove four 10 mm bolts securing
radio, unsnap, and remove.
(Figure C)
4. Remove two plastic snaps from
factory radio and install onto
radio panel.
Continue to kit assembly
(Figure A)
(Figure B)
(Figure C)
99-8159S
ISO DIN radio provision
with pocket
1. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
2. Slide the radio into radio brackets
and secure with screws supplied
with the radio. (Figure A)
3. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
4. Mount the new radio assembly
into the dash snap the radio panel
over that and reassemble dash in
reverse order of disassembly.
2

Kit Assembly

(Figure A)