Wiring Diagram - Metra 99-8159S Instrucciones De Instalación

Kit Assembly
Double DIN radio provision
1. Mount the radio brackets to the
aftermarket radio and secure
with screws supplied with the
radio. (Figure A)
2. Locate the factory wiring
harness and antenna plug in the
dash. Metra recommends using
the proper mating adapters from
Metra and/or AXXESS.
3. Mount the new radio
assembly into the dash and
reassemble dash in reverse
order of disassembly.
(Figure A)
99-8159S

Wiring Diagram

For the climate controls to operate properly, the
following steps need to be followed:
1. Locate the 20-way or 12-way white
connector that was plugged into the
factory radio.
Note: 04'-06' RX330 & 06' RX400H have
a 12-way connector and require the
resistor to be added between the Yellow
in pin 9 and Brown in pin 10.
Note: 07'-09' RX350 & 07'-09' RX400H
have a 20-way connector and require
the resistor to be added between the
Red in pin 9 and Black in pin 10.
10 9
Join resistor to wires 9 and 10
3
Note: 07'-09' RX350 & 07'-08' RX400H
with factory navigation have a 12-way
connector and require the resistor to be
added between the Black in pin 9 and
White in pin 10.
2. Strip back the two factory wires, connect
one side of the 68 OHM resistor to one wire
and connect the other side of the resistor to
the other wire (see diagram below).
3. When completed be sure to tape up the
wires including the resistor to protect them
from coming into contact with any metal,
and push the connector back into the dash
(see diagram below).
10 9
10 9 8 7 6
Splice resistor Back view, 20-way plug
9 10
Back view,
12-way plug