Preparatory Activities; Greasing The Ram Surface - Zipper Maschinen ZI-HS10TN Instrucciones De Servicio

15 TRANSPORT
For easier transport, the log splitter has two wheels, a support wheel and a transport handle.
16 OPERATION
16.1

Preparatory activities

16.1.1 Greasing the ram surface

Apply a thin layer of grease to the surface of the ram of your log splitter before starting work. This
will prolong the life of the tool.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS10TN / ZI-HS12TN / ZI-HS14TN
WARNING
 If a crane is used, tie the rope at the lifting point
belwo the blue bundling label, then hoist the
machine with the crane see illustration on the left.
 Never attach the crane hook to the transport
handle (a)!
 Before moving the log splitter, make sure that the
cover on the oil tank is firmly closed!
 To move the splitter, grasp the handle (a) and
carefully tilt machine backwards!
A. Moving support
position: To mount the support wheel, remove the
spring bolt and push the square tube with the
support wheel into the holder (1). Then select the
upper hole for transport and fix the square tube in
that position using the spring bolt (2).
The upper hole is for transport and the
lower hole is for storage only.
B. Fold out the transport handle: The transport
handle is normally fixed in an upright position. To
transport the log splitter, the transport handle must
be folded out as shown in the illustration on the left.
To unfold, release the pin (1), unfold the transport
handle (2) and fix it in the unfolded position using
the pin (3).
TRANSPORT
wheel to the
CAUTION
transport
29