Storage - Craftsman 919.167321 Instrucciones De Seguridad E Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Regulator
4.
Remove the regulator.
5.
Apply pipe sealant tape to the
nipple.
6.
Assemble the regulator and
orient as shown.
Regulator
Before you store the air compressor,
make sure you do the following:
1.
Review the Maintenance section
on the preceding pages and per-
form scheduled maintenance as
necessary.
2.
Set the On/Auto/Off lever to "Off"
and unplug unit.
3.
Turn the regulator counterclock-
wise and set the outlet pressure to
zero.
4.
Remove the air tool or accessory.
5.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately 20
psi. Release safety valve ring.
6.
Drain water from air tank by open-
ing drain valve on bottom of tank.
A17883
Outlet
Pressure
Gauge
Quick
Connect
Niple

STORAGE

18 - ENG
NOTE: Arrow indicates flow of air.
Make sure it is pointing in the
direction of air flow.
7.
Reapply pipe sealant to outlet
pressure gauge and quick
connect.
Regulator
Arrow
8.
Reassemble outlet pressure
gauge and quick connect. Orient
outlet pressure gauge to read
correctly. Tighten quick connect
with wrench.
in the air tank. If not drained, water
will corrode and weaken the air tank
causing a risk of air tank rupture.
7.
After the water has been drained,
close drain valve by turning clock-
wise.
NOTE: If drain valve is plugged,
release all air pressure. The valve
can then be removed, cleaned, then
reinstalled.
8.
Protect the electrical cord and air
hose from damage (such as being
stepped on or run over). Wind
them loosely around the com-
pressor handle.
9.
Store the air compressor in a
clean and dry location.
Risk of Bursting.
Water will condense

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido