Adjusting The Temperature - Heatworks 1X Manual Del Usuario

8

ADJUSTING THE TEMPERATURE

After the MODEL 1X has been properly installed and is
receiving power, the digital display will show the current
water temperature setting (115º).
STEPS
1) Press the top button to increase the temperature
setting. Press the bottom button to decrease the
temperature setting.
CAUTION: Breaker must remain off until installation is complete.
12
Outlet / Top
Inlet / Bottom
2) Temperature setting can be changed in increments of
1° with a maximum setting of 120° F (49° C).
3) Verify your desired temperature appears on the digital
display.
HEATWORKS RECOMMENDS: Because newer model
dish washers are typically equipped with an internal
heating element, and most laundry detergents are
intended for use in cold or warm water, there is no
longer a need to set your water heater to a temperature
above 120 °F.
SWITCHING BETWEEN FAHRENHEIT AND CELSIUS
STEPS
1) Press both buttons at the same time and release the
bottom button for °C.
2) Press both buttons at the same time and release the
top button for °F.
CONGRATULATIONS!
YOU HAVE COMPLETED THE INSTALLATION OF THE
HEATWORKS MODEL 1X.
www.myheatworks.com