Utilitech 7105-06 Manual Del Usuario página 10

Ventilador decorativo con luz led
Ocultar thumbs Ver también para 7105-06:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
5.
Secure the fan housing (A) to joist with suspension
brackets (E, F, G) using long wood screws (AA).
Note: Bottom of fan housing should be flush with the
bottom of the ceiling board. When mounted correctly, the
LED panel mounting bar will hang below the ceiling board.
Optimum spacing from the bottom of the ceiling board
to the bottom of the mounting bar is 3/4 in. (5.1).
Hardware Used
AA
Long wood screw
6.
Secure the suspension brackets (E, F) to fan housing (A)
using small machine screw (CC).
Hardware Used
CC
Small machine screw
7.
Remove wiring box cover (7.1). Pull the house wires
through the wire box cover hole. Using a quick connector,
secure 120 V AC house wiring from the wall switch to
the fan as shown in the wiring diagram on page 5. 14
AWG is the smallest conductor that should be used for
branch-circuit wiring.
Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover (7.1).
CAUTION: If the electrical wires do not match the colors
listed, you must determine what each house wire
represents before connecting. You may need to
consult an electrical contractor to determine safely.
8.
Connect a 4 in. circular duct (8.1) (not supplied) and vent
to the outside. Secure it with duct tape (not supplied) or
clamp (not supplied) to make connection secure and
air tight.
Turn on power source. Check fan for any abnormal
sound or vibration.
5
x 6
Ceiling board
Mounting bar
6
x 3
E
7
7.1
7.1
8
10
A
AA
View of fan
housing from
the top
AA
F
Side view
of fan housing
A
CC
CC
House
Quick
wires
connector
8.1
E
AA
G
3/4 in .
5.1
CC
F
Product
wires
7.1
7.1

Publicidad

Tabla de contenido
loading

Tabla de contenido