Utilitech 7105-06 Manual Del Usuario página 7

NEW CONSTRUCTION ASSEMBLY INSTRUCTIONS
4. Secure the suspension brackets (E, F) to fan housing (A)
using small machine screw (CC).
Hardware Used
CC
Small machine screw
5. Remove wiring box cover (5.1). Pull the house wires
through the wire box cover hole. Using a quick connector,
secure 120 V AC house wiring from the wall switch to
the fan as shown in the wiring diagram on page 5. 14
AWG is the smallest conductor that should be used for
branch-circuit wiring.
Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover (5.1).
CAUTION: If the electrical wires do not match the colors
listed, you must determine what each house wire
represents before connecting. You may need to
consult an electrical contractor to determine safely.
6. Connect a 4 in. circular duct (6.1) (not supplied) and vent
to the outside. Secure it with duct tape (not supplied) or
clamp (not supplied) to make connection secure and
air tight.
Turn on power source. Check fan for any abnormal
sound or vibration.
7. Plug in LED panel (B) into the fan housing (A).
Plug in wire connectors (2 hole and four hole) from fan
motor into fan housing.
4
A
x 3
E
CC
5
5.1
5.1
6
7
LED
connector
7
CC
CC
House Quick
connector
wires
Product
wires
6.1
2
holes
F
5.1
4
holes