NEW CONSTRUCTION ASSEMBLY INSTRUCTIONS
8.
Secure the LED panel (B) to the fan housing (A)
using 4 long machine screws (BB) and metal washers
(DD).
Hardware Used
BB
Long machine screw
DD
Metal washer
9.
Choose which rim (C) finish suits your room. Lay glass
globe (D) into chosen rim (C).
10. Line up the three notches around the outside of the LED
panel (B) with the three clips on the rim (C). Gently push
up the rim (C) and glass globe (D) as far as possible until
it stops.
11. Rotate the rim (C) until it hits the stop and cannot be
rotated any further. Slowly pull hands away and glass
globe (D) and rim (C) will be attached to the fan housing
(A).
8
x 4
x 4
9
10
Notch
Clip
11
D
8
C
Clip
Notch
Clip
D
Notch
A
C