Tips And Recommendations For Installation - SOMFY ALTUS RS 50 io Guía De Usuario

2. 3. 5. Programming the first local Somfy io-homecontrol® control point
The "definitive" programming of the first control point can only be performed if the motorised
product travel end stops are set.
A. PROGRAMMING OF THE PRE PROGRAMMED SOMFY IO HOMECONTROL® LOCAL CONTROL POINT
Press the PROG button on the pre-programmed control
point: the motorised product will move up and down; the
control point has been programmed definitively.
B. PROGRAMMING A CONTROL POINT THAT HAS NOT BEEN
PRE PROGRAMMED
Cut the mains power supply (the pre-programmed control
1)
point is now deleted).
Restore the mains power supply. The motorised product
2)
moves up and down briefly.
Press the "Up" and "Down" buttons simultaneously until the
3)
motorised product moves up and down.
Press the PROG button on the control point briefly: the
4)
motorised product will briefly move up and down; the
control point has been programmed.

2. 4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2. 4. 1. Questions about the drive?
Observations
The motorised
product does not
operate.
The motorised
product stops too
soon or too late.
2. 4. 2. Re-programming the travel end stops
An io control point must be programmed definitively to complete these steps.
Readjusting the travel end stops
Position the motorised products in its travel end stop
1)
position that requires adjustment.
Press the "Up" and "Down" buttons simultaneously until the
2)
motorised product moves.
Position the motorised product in its new travel end stop
3)
position using the "Up" or "Down" buttons.
Press the "my" button until the motorised product moves,
4)
to confirm the adjustment.
Copyright © 2016 Somfy SAS. All rights reserved.
Possible causes
The wiring is incorrect.
The motor is hot.
An incorrect cable has been used.
The Somfy io control point battery is
low.
The control point is not compatible.
The Somfy io control point used has
not been programmed into the motor.
The crown is incorrectly positioned.
The end limits have been incorrectly
set.
PROG.
1)
OFF
3)
Solutions
Check the wiring and modify it if
necessary.
Wait until the motor cools down.
Check the cable being used and make sure
that it has 3 conductors.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or
program this control point.
Fit the crown correctly.
Readjust the end limits.
1)
3)
Images not contractually binding
EN
2)
ON
4)
PROG.
2)
5 seconds.
4)
39