Publicidad
Idiomas disponibles
Idiomas disponibles
1
4
Car Seat Adapter Installation:
1 Remove caps from attachment points on stroller.
2 Place the adapters onto the corresponding
attachment points.
N OTE: The right and left attachment points on
your stroller are determined by standing in
front of and facing the stroller.
N OTE: To ensure a secure lock, make sure
nothing is caught between the adapters and
the attachment points, including blankets, seat
liners, stroller fabric, etc.
3 Press the locking switch down until the car seat
adapter locks into place. A green circle will be
visible when the adapter bracket is locked into
place. If red is visible, the adapter is not properly
installed and may result in injury to your child.
4 Place car seat onto adapters and press down
firmly until it clicks into place. Fasten and
properly tighten the Adapter Bracket Safety
Belt over the car seat before operation.
5 To remove car seat:
• Engage car seat release lever found on back
of car seat and lift up.
2
CLICK
To remove adapter brackets:
• While pressing and holding the release button
on side of bracket, raise the locking switch
to unlock the adapter. Remove from stroller
frame.
WARNING:
• Keep these instructions for future reference.
• Read these instructions carefully before use.
Your child' s safety may be affected if you
don't follow these instructions.
• NEVER leave child unattended.
• IMPORTANT! While the child is in the carseat,
always use the restraint system provided by
the manufacturer.
• WARNING: Check that the pram body or
seat unit or car seat attachment devices are
correctly engaged before use.
• Accessories
manufacturer shall not be used.
• Only use replacement parts supplied or
recommended by the manufacturer.
• Wipe clean using a damp cloth.
2
3
5
not
approved
by
the
Publicidad
