Cleaning The Appliance; Information & Service - Philips Ladyshave HP6307/00 Manual Del Usuario

ENGLISH
3
3 Move the Ladyshave slowly over the skin.
You can move the Ladyshave up and down or from
left to right (fig. 9), depending on which movement
you find most pleasant.
4 Switch the appliance off by moving the slide
(F) to position O (fig. 8).
Storage
1 Put the protection cap on your Ladyshave
after use.
The protection cap prevents the shaving foil and two
trimmers from becoming damaged.

Cleaning the appliance

Clean the Ladyshave every time you have used it.
Do not use any corrosive detergents, scouring pads
or cloths, petrol, acetone etc. to clean the appliance.
Do not exert any pressure on the shaving foil to
avoid damage.
After each use
1 Switch the appliance off.
2 Rinse the appliance under the tap (fig. 10).
Do not clean, rinse or immerse the Ladyshave in
water if the cover of the battery holder is not
properly closed.
Do not use water that is hotter than shower
temperature to clean the appliance.
1 Remove the shaving head (B) from the
appliance (fig. 11) to clean the hair chamber
and the shaving head.
2 Rinse the hairs off the shaving head (fig. 12)
and the appliance (fig. 13).
3 Put the shaving head back onto the appliance
('click').
From time to time
Once a year in case of normal use.
1 Remove the shaving head (B) from the
appliance (fig. 11).
2 Release the shaving foil unit from the trimmer
unit (1) and separate the two units (2) (fig. 14).
3 Brush the shaving foil and the cutter block
carefully (fig. 15).
4 Place the shaving foil unit on a solid and flat
surface and press the trimmer unit back onto
the shaving foil unit (fig. 16).
5 Put the shaving head back onto the appliance
('click').
Maintenance and replacement
1 Lubricate the shaving foil with a drop of
sewing machine oil twice a year (fig. 17).
If you use the Ladyshave twice a week or more, we
advise you to replace the shaving foil and cutter
block every one to two years.
Ladyshave
HP6307/00, HP6301/00
The shaving foil may only be replaced with an
original Philips shaving foil (type HP2904).
The cutter block may only be replaced with an
original Philips cutter block (type HP2907).
The environment
Make sure the batteries are completely empty when
you dispose of them.
Do not throw batteries away with the normal
household waste, but hand them in at an official
collection point.
Information & service
If you need information or if you have a problem,
please visit the Philips Web site at www.philips.com
or contact the Philips Customer Care Centre in your
country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer
Care Centre in your country, turn to your local
Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.
4222 002 28032