Publicidad
Idiomas disponibles
Idiomas disponibles
A
B
1
Take the front preassembled leg sub-assembly (A) (without
hole drilled behind leg) and insert one of the side support
tubes (C) into the legs protruding mount keeping the support
tubes screw hole facing the oor. Repeat for the opposite side
and screw both side support tubes with included screws (G).
(C)
3
Take front preassembled console legs (A) (without holes drilled
behind legs) and the top U shaped mounting bracket (E) and
place bracket over the protruding studs on top of the front and
rear console legs (A&B) as illustrated keeping the open end of
the bracket to the rear of console.
Note: The screw holes on the top bracket where the screws are
placed through are tapered or chamfered on one side of the
bracket to properly t the head of the screw for a at, ush nish.
Use 4 supplied screws (H) to attach bracket to preassembled legs.
(H)
Front of
Console
C
D
E
CONSOLE ASSEMBLY
(A)
(E)
Back of
Console
(A)
(B)
8721 CONSOLE TABLE COMPONENTS LIST
ITEM # QTY.
DESCRIPTION
A
1
FRONT LEG SUB-ASSEMBLY (WITHOUT HOLES IN LEGS)
B
1
REAR LEG SUB-ASSEMBLY (WITH HOLES IN REAR OF LEGS)
C
2
SIDE SUPPORT TUBES
D
1
REAR WALL MOUNTING BRACKET
E
1
U SHAPED TOP MOUNTING BRACKET
F
4
SILICON SINK MOUNTING PADS
G
4
M6 x 12.0 HEX ALLEN HEAD MACHINE SCREWS
H
4
M6 x 33.1 HEX ALLEN HEAD MACHINE SCREWS
J
2
M6 x 6.3 HEX ALLEN HEAD MACHINE SCREWS
K
4
RUBBER BUMPERS
F
G
2
Attach rear preassembled leg sub-assembly (B) (with
hole drilled behind legs) to both side support tubes.
Screw both parts together with supplied screws (G).
(B)
(G)
4
Take rear wall mounting bracket (D) (used to mount console
to wall) and attach to rear leg sub-assembly (B) ensuring the
bend in the bracket protrudes slightly towards the wall and
mount using supplied screws (J).
Level front-to-back
Adjustable foot
bumper
Feet are adjustable
2
H
J
(G)
Level side-to-side
(B)
7302364-100 Rev. 2 (3/19)
K
(G)
(D)
Publicidad
