American Standard Town Square S 0297 Serie Instrucciones De Instalación Cuidado Y Mantenimiento página 4

3
Anchor Screw Installation
1. Move the assembly well clear of the wall.
2. Drill two pilot holes at the center marks using a 1/4" drill bit for the sink screws.
3. Drill two additional pilot holes at the center marks below the sink if mounting for
the Console.
4. Thread the two headless hanger screws (supplied) into the sink mounting holes leaving 1-7/8" (48 mm)
of the threaded end exposed as illustrated. If using console, mount to wall with screws (not supplied).
4
Faucet and Drain Installation
1. Following manufacturer's instructions, install faucet and drain assembly
(not included).
2. Apply a bead of sealing putty on the underside of the drain (see detail A)
in order to ensure a watertight seal between the sink and the drain.
Remove excess putty after installing drain on sink.
3. Return the sink assembly to the installed position, guiding the sink over
the two headless hanger screws.
4. Connect the trap to drain assembly and hand-tighten to check alignment.
It may be necessary to cut off part of the tailpiece (see detail B) or part
of the horizontal leg of the trap (see detail C).
5
Sink and Pedestal/Console Installation
1. Secure sink or console to wall, install washers and hand tighten nuts. For console, screw to
wall using 1/4" screws (not provided).
2. Connect hot and cold supply lines between the tting valve and the supply shut-off valves.
3. Tighten trap joints for watertight assembly.
4. Apply a bead of caulk around the back edge of the sink where it contacts the wall.
CONSOLE CARE INSTRUCTIONS: Rinse the product clean with clear water. Dry with a soft cotton flannel cloth.
DO NOT: Clean with soaps, acid, polish, abrasives, harsh cleaners, or a cloth with coarse surface.
4
A
C
B
1-7/8"
(48 mm)
Lavatory
Anchor
Screw
Nut
Washer
7302364-100 Rev. 2 (3/19)