Skil LT4823B-00 Manual Del Propietário página 19

4. Push down on the trimmer head while pulling on the lines to manually advance the line
and to check for proper installation of the cutting line.
Reload the Cutting Line
NOTICE: When the cutting line breaks from the line outlet or the cutting line is not released
when the trimmer head is tapped, you need to remove the remaining cutting line from the
spool retainer and follow the steps below to reload the line.
1. Remove the battery pack from the trimmer.
2. Press the release tabs on the upper cover and remove the lower cover of the trimmer
head by pulling it straight out (Fig. 18 and 19).
Fig. 18
3. Remove the cutting line from the spool
retainer.
4. With one hand holding the upper cover,
use the other hand to grasp the lower cover
of the trimmer head and align the tabs on
the upper cover with the holes in the lower
cover; use your palm to press the lower
cover until it snaps into place (Fig. 20).
5. Follow the instructions in "Line
Replacement" to reload the cutting line.
Release Tab
Fig. 19
Upper Cover
Fig. 20
Alignment
Lower Cover
19