Assembly And Operation - Worx WX371 Manual Original

This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WX371
Charger 1(WA3860)
Battery pack 1(WA3551.1) 2(WA3551.1) 2(WA3550.1)
Double Ended
Bit (PH2/SL5.5)
158pcs
10
accessories
55pcs
accessories
30pcs
accessories
WX371.3
Charger 1(WA3760)
Battery pack 2(WA3550.1) 3(WA3551.1)
Double Ended
Bit (PH2/SL5.5)
158pcs
accessories
55pcs
accessories
30pcs
accessories
WX371.6 WX371.7 WX371.9 WX371.10
Charger 1 (WA3760) 1 (WA3860)
Battery pack 2 (WA3551.1) 2 (WA3551.1)
Double
Ended Bit 1
(PH2/SL5.5)
Cordless hammer drill
WX371.1 WX371.2
1(WA3860) 1(WA3760)
1 1
/ /
/ /
/ /
WX371.4 WX371.5
1(WA3860) 1(WA3760)
2(WA3551.1)
1 1
/ /
/ /
/ /
/ 1 (WA3760)
/ 2 (WA3551.1)
/ 1
158pcs
accessories
55pcs
accessories
30pcs
accessories
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
ASSEMBLY AND
OPERATION
/
1
/
BEFORE OPERATION
/
Removing the battery pack
Charging the battery pack
Installing the battery pack
ASSEMBLY
/
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch
/
and disconnect tool from power source when
changing accessories. Always ensure the bit is secure
before starting the tool. Damage to the Chuck or a
1
loose bit may cause possible personal injury.
/
--Removing the bits
--Inserting the bits
OPERATION
FORWARD/REVERSE ROTATION
CONTROL
WARNING: Never change the
/
direction of rotation when the chuck
is rotating, wait until it has stopped!
/ / /
/ 1 /
/ / /
ACTION
/
/
1
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig.C1,
C2, C3
EN