Assembly And Operation - Worx WX175 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE (FOR WX175 WX175.1 WX175.2 WX175.9)
The machine is intended for driving in and loosening screws as well as for drilling in wood,
metal and plastic.
INTENDED USE (FOR WX373 WX373.1 WX373.2 WX373.9)
The machine is intended for impact drilling in brick, concrete and stone as well as for drilling in
wood, metal and plastic.

ASSEMBLY AND OPERATION

BEFORE OPERATION
Checking the battery charge condition
Removing the battery pack
Charging the battery
Installing the battery pack
12
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and disconnect tool from power source when
changing accessories. Always ensure the bit is secure before starting the tool. Damage to the
Chuck or a loose bit may cause possible personal injury.
-- Removing the bits
-- Inserting the bits
Assembling the belt hook and bit clip
OPERATION
FORWARD/REVERSE ROTATION CONTROL
WARNING: Never change the direction of rotation when the
chuck is rotating, wait until it has stopped!
TWO-SPEED GEAR CONTROL
TORQUE ADJUSTMENT
SCREWDRIVING, DRILLING, HAMMER DRILLING
Lithium-Ion Brushless drill driver
Lithium-Ion Brushless hammer drill
ACTION FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig. B1
See Fig. B2
See Fig. C1, C2, C3, C4
See Fig.D1, D2, D3
See Fig. E
See Fig. F1, F2, F3
EN