Complete The Finished Wall; Finish The Installation - Kohler Sterling 7613 Serie Guia De Instalacion

Finished Wall
Clear 100%
Silicone Sealant
Whirlpool with Water-Resistant
Wall Material and Finished Wall

11. Complete the Finished Wall

NOTE: Locate and size the holes for the valves, shower control, spout, and/or shower in the walls
according to the manufacturer's requirements.
IMPORTANT! When applying the water-resistant wall material over the whirlpool flange, leave a 1/4" (6
mm) gap between the whirlpool rim edge and the wall material. This gap helps to reduce the possibility
of water seeping into the wall material.
Brush all dust and debris from the whirlpool flange.
Cover the framing with water-resistant wall material.
Seal the 1/4" (6 mm) gap between the whirlpool rim edge and the water-resistant wall material with
clear 100% silicone sealant.

12. Finish the Installation

CAUTION: Risk of property damage. Make sure that a watertight seal exists around the drain and
overflow.
Install the faucet trim, whirlpool spout, shower door, and any accessories according to each
manufacturer's instructions.
Remove the protective covering from the whirlpool.
Open the water supply lines, then run the water to flush out any debris.
Close the valves.
Check all connections for leaks.
If applicable, install all other accessories according to the manufacturer's instructions.
1072813-2-A
Water-Resistant
Wall Material
Whirlpool Flange
1/4" (6 mm)
Tile or Other
Wall Finish
Clear 100%
Silicone Sealant
Whirlpool with Tile,
Marble, Etc.
16
Water-Resistant
Wall Material
Whirlpool Flange
1/4" (6 mm)
Sterling