Klarfit Treado Active Manual Del Usuario página 37

Adjustment of the running belt
The running belt can expand after prolonged use and must then be readjusted.
Let the treadmill run at a speed of 3 km/h. Turn the rear adjustment screws
with the supplied Allen wrench to center the belt.
When the treadmill moves to
the right, turn the right adjusting
screw 1/4 turn clockwise and
the left adjusting screw 1/4 turn
counterclockwise. Continue turning
the adjustment screws until the
treadmill is correctly centered.
If the running belt slips during use, turn the treadmill off and unplug it. Use
the supplied Allen wrench to turn the left and right adjustment screw 1/4
turn clockwise to tighten the belt or 1/4 turn counterclockwise to loosen
the belt. Re-insert the plug and start the treadmill at a speed of 8-10 kph.
Continue running on the treadmill to determine if the belt is still slipping.
Repeat until the belt stops slipping.
When the treadmill moves to
the left, turn the left adjustment
screw 1/4 turn clockwise and the
right adjustment screw 1/4 turn
counterclockwise. Continue turning
the adjustment screws until the
treadmill is correctly centered.
EN
37