jbc T210 Serie Manual Del Usuario página 3

Nitrogen Handles features
These are for working in an oxygen-free atmosphere providing better quality soldering.
They offer extra heat to the solder joint and help prevent oxidation. The JBC GN-A Nitrogen
Generator Module or an external nitrogen feed is needed at the operator's bench.
For C210 Cartridge range
Nitrogen Precision Handle
Ref. T210-NA
For C245 Cartridge range
Nitrogen Handle
Ref. T245-NA
For C470 Cartridge range
Nitrogen HD Handle
Ref. T470-NA
Changing cartridges
Before changing the cartridge
Nozzle
First remove the nozzle. Then loosen the screw
to remove the cartridge (T245-NA / T470-
NA). Use a pliers to change or remove
nozzles when hot.
4 4 4
Nitrogen feed
Nozzles
Ref. B6647
Nitrogen feed
Nozzles
Ref. B7243
B7244
Nitrogen feed
Nozzles
Ref. B6193
B6194
B6195
After changing the cartridge
Mark
Insert the cartridge, tighten the screw and
then place the nozzle.
T210 & T245 Changing cartridges
Save time and change cartridges safely without switching the station off.
1. Removing 2. Inserting
Place the handle in the Place the handle on top of
extractor and pull to the new cartridge and press
remove the cartridge. down.
Important
*
It is essential to insert the cartridges as far as the mark for a proper connection.
Mark
T470 Changing cartridges
1. Removing
Loosen
Loosen the screw. Place the Soldering Iron
in the extractor and remove the cartridge.
w w w.jbctools.com
3. Adjusting
C
D
B
A
Use the holes for fixing the
cartridge* as follows:
A. For straight C210.
B. For curved C210.
C. For curved C245.
D. For straight C245.
2. Inserting
Insert the new cartridge* and press slightly
as far as the mark and tighten the screw.
5 5 5