From the 22-pin Chrysler harness
• Connect the Yellow wire to the radio's 12 volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the Blue wire to the radio's antenna turn on wire if populated on the
factory side.
Amplified vehicles
• Connect the two 4-pin connectors with the Purples and Greens wires
in it together.
Non-amplified vehicles
• Disconnect the two 4-pin connectors with the Purples and Greens in it.
• From the 22-way Gray connector, connect the 4-pin with the Whites
and Grays to the 4-pin with the Purples and Greens coming from the Black
22-way connector.
• Connect the 4-pin harness with stripped leads to the 4-pin with the Greens and
Purples coming from the Gray 22-pin connector.
AX-ADCH100
Installing the Interface
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative
12-way harness
This harness is for the ASWC-1 (sold separately). Please refer to the ASWC-1
instructions for programming.
Installing the AX-ADCH02
• With all connections completed to the aftermarket radio, plug the 22-pin
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again
6
speaker output.
harness into the vehicles wiring harness.
to test the radio.