Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8. Use upper hole in the back of RH mounting
bracket as a template to drill hole through
inner side of corner post on pickup bed
(FIG. 13-1). Then, bolt RH mounting bracket
to corner post of pickup bed as shown in
FIG. 13-1. Repeat for LH mounting bracket.
9. Unlatch and unfold platform. Refer to
operation manual if needed. Then, adjust
liftgate position so platform is level from
front to back.
10. Securely tighten bolts fastening RH mount-
ing bracket to main frame bracket (FIG.
13-1). Ensure the split lock washers are not
in the slotted holes on main frame bracket.
Repeat for LH mounting bracket.
11. Reinstall taillights (FIG. 13-1).
LIFT CORPORATION Sht. 13 of 52 DSG#
INSTALLING LIFTGATE - Continued
M-16-32
ALUMINUM
SPACER
RH MOUNTING
BRACKET
3/8"-16
HEX BOLT
DRILL HOLE,
3/8" DIA.
CORNER
POST
BOLTING RH MOUNTING BRACKET
TO PICKUP BED (LIFTGATE NOT SHOWN)
FIG. 13-1
Rev. B Date: 09/21/18
3/8" FLAT
WASHER
3/8" LOCK
WASHER
3/8"
HEX NUT
TAILLIGHT
Publicidad
Tabla de contenido
