Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING CAMERA AND SENSORS (IF EQUIPPED) - Continued
3. Adjust camera angle by loosening
1/4" hex bolt and lock nut. Then rotate
camera mounting bracket to correct
angle as shown in FIG. 21-1. Tighten
hex bolt and lock nut when desired
camera angle is set.
4. Install each of the OEM sensors (if
equipped) into 4 brackets as shown
in FIGS. 21-2 & 21-2A.
5. Use plastic ties (Kit item) to secure
sensors to mounting brackets as
shown in FIG. 21-2A.
6. Connect OEM sensor harness on
the vehicle to all sensors.
LIFT CORPORATION Sht. 21 of 52 DSG#
OEM SENSOR
(4 PLACES)
SENSOR MOUNTING
BRACKET
(4 PLACES)
CAMERA MOUNTING
BRACKET AND OEM
CAMERA
60° MAXIMUM
TILT
ADJUSTING CAMERA ANGLE
SENSOR MOUNTING
BRACKET
OEM SENSOR
INSTALLING SENSORS (IF EQUIPPED)
FIG. 21-2
M-16-32
Rev. B Date: 09/21/18
LOCK NUT 1/4"-20
CAMERA BASE
FIG. 21-1
FIG. 21-2A
BRACKET
PLASTIC
TIE
Publicidad
Tabla de contenido
