THOMSON WS02 Instrucciones De Instalación página 10

Ocultar thumbs Ver también para WS02:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Charging the speaker (3.7V rechargeable battery built-in)
1. Connect WS02 to PC/Laptop/Mac or any 5V USB adaptor (not included) via the USB cable
included.
2. RED LED turns ON during charging, turns OFF after fully charged.
3. Unplug USB cable after fully charged.
4. BLUE LED twinkles when power is lower than 21%, with voice talk "Battery Level Low".
5. Speaker turns off automatically in 5 minutes if no pairing action.
Pairing with Bluetooth enabled devices (Mobile phones/Tablets etc.)
1. Keep the speaker and device within 1 meter of each other.
2. Hold the power button for 2 seconds to turn the speaker on, LED of volume buttons turn on in blue
color for 10 seconds.
3. LED of Bluetooth/Hand-free LED blinks quickly in blue with voice talk "Bluetooth Mode", while the
speaker enters search mode.
4. Start the Bluetooth function on your mobile device and look for "WS02" in the Bluetooth device
list (depending on the Bluetooth version of your device you may need to enter pass code '0000').
5. After successfully paired, the LED will change to solid blue, with voice talk "Bluetooth paired".
Note:
• If pairing is not successful, turn off the speaker and re-pair again.
• After successful pairing, paired devices will remember each other so there is no need to pair again
unless pairing information is deleted.
• To pair with a new device, just follow steps 1-5 above after disconnect with existing device.
Re-connecting to a paired device
If the speaker does not connect to the last used device automatically, then you will need to select it
manually from the list of devices on your mobile device.
Break existing Bluetooth connection
1. When speaker is paired with any device already, hold the Bluetooth button for 3 seconds to break
existing connection with voice talk "Bluetooth Disconnected", then you can connect to other
devices.
2. If paired device is disconnected by out of range, then it will reconnect when back to the range.
It will turn off automatically if out of range more for than 5 minutes.
- EN 3 -

Publicidad

Tabla de contenido
loading

Tabla de contenido