Control Panel And Remote Control - Pur Line COOLY 9000 A Manual De Instrucciones

CONTROL PANEL AND REMOTE CONTROL

temperature.
ADJUST FAN SPEED
Press the speed button
TURN OFF
When you press power button
MODES
AUTO
1.Once the AUTO mode is selected, the indoor temperature sensor operates automatically to
select the desired operation mode with or Cool or Fan.
2. When the room temperature ≥24ºC, the unit will automatically select Cool mode.
3. When the room temperature <24ºC, the unit will automatically select Fan mode.
DEHUMIDIFY
1. The fan will run at low speed, the speed can't be adjusted.
2. The compressor will stop after running 8 mins, then run again after 6 mins.
3. The unit adopts constant temperature dehumidifying mode, temperature can't be adjusted.
COOL
1. When the room temperature is higher than set temperature, the compressor starts to run.
2. When the room temperature is lower than set temperature, the compressor stops and fan
operates at original set speed.
FAN
1. The fan runs at set speed, the compressor is not workning. Temperature can't be adjusted.
TIMER
1. Press Timer button to set Automatic Off time while the unit is running.
2. Press Timer button to set Automatic On time while the unit is ready.
3. The time can be adjusted within a range of 1 hour to 24 hour. Press
or decrease the time 1 hour by pressing once.
EN
to select a desired fan speed: low - medium - high.
again, the unit will emit "di" and stop working.
31
TURN ON THE UNIT
- Plug in, the unit beeps once.
- Press the power button
device.
The LED displays the room temperature and
operate in Automatic mode.
SELECT OPERATING MODE
Press the mode button
mode shown below:
Auto -> Cool -> Dehumidifier -> -> Fan
ADJUST TEMPERATURE
The temperature can be set within a range of
15 °C to 31 °C by 1°C.
Press or button to increase or decrease
the temperature 1°C.
The unit LED shows the target temperature
for 5 seconds and then displays the room
to turn on the
to select a desired
o button to increase