Assembly & Set-Up; Contents Of Carton - Troy-Bilt 2690XP Manual Del Operador

Assembly & Set-Up

Contents of Carton

• Snow Thrower (1)
• Chute Assembly (1)
• Engine Operator's Manual (1)
Assembly
Handle
1. Place the shift lever in the Forward-6 position.
See Figure 3-1.
Figure 3-1
2. Observe the lower rear area of the snow thrower to be
sure both cables are aligned and seated properly in roller
guides. See Figure 3-2.
• Replacement Auger Shear Pins (2)
• Product Registration Card (1)
3. Pivot handle upward and align the tab at the end of the
upper handle with the hole in the lower handle. Secure the
handle by tightening the plastic knob located on both the
left and right sides of the handle. See Figure 3-1. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
• Chute Control Rod (1)
• Snow Thrower Operator's Manual (1)
Figure 3-2
3
7