Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND SERVICE INSTRUCTIONS FOR FEDERAL MODEL 224XSTHI
VISUAL SIGNAL APPLIANCES FOR THE HEARING IMPAIRED
SAFETY MESSAGE TO INSTALLERS, USERS AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is to be installed by
a trained electrician who is thoroughly familiar with the National Electrical Code and will follow the NEC
Guidelines as well as local codes.
This device should be considered a part of the warning system and not the entire warning system.
The selection of the mounting location for the device, its controls and the routing of the wiring are
to be accomplished under the direction of the facilities engineer and the safety engineer. In addition, listed
below are some other important safety instructions and precautions you should follow:
•
Read and understand all instructions before installing or operating this equipment.
•
Never alter the unit in any manner. Safety may be compromised if additional openings or
other alterations are made to the unit.
•
Do not connect this light to the system when power is on.
•
After installation, ensure that the setscrew and threaded joints are properly tightened.
•
Keep unit tightly closed when in operation.
•
After testing is complete; provide a copy of this instruction sheet to all
operating personnel.
•
Establish a procedure to routinely check the light installation for integrity and
proper operation.
Failure to follow all safety precautions and instructions may result in property damage, serious injury,
or death to you or others.
I.
GENERAL.
The Model 224XSTHI strobe light is a Visual Signaling Device for the Hearing Impaired for use in
Hazardous Locations and provides about 80 high intensity flashes per minute. The unit is UL Listed for
indoor use on a wall or ceiling in a nonsleeping area and complies with the TYPE 4X (watertight and
corrosion resistant) and IP66 (dust-tight and protection against heavy seas) enclosure requirements.
For the Electrical Ratings and Light Dispersion Pattern of the Model 224XSTHI, reference Table 1 and
Figure 1.
II.
INSTALLATION.
A.
Unpacking.
Damaged globes can lead to explosions, which could result in serious injury or death.
After unpacking the unit, examine it for damage that may have occurred in transit. If the
equipment has been damaged, do not attempt to install or operate the unit. File a claim immediately with
the carrier, stating the extent of damage. Carefully check all envelopes, shipping labels and tags before
removing or destroying them.
FOR USE IN HAZARDOUS LOCATION
-1-
Publicidad
