Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade ELLINGTON Triad TRI54BNK3 Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 9 blade attachment screws and
washers in one of the hardware packs. Place
blade on top of blade arm, aligning holes in
blade with holes in blade arm as shown.
Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for remaining blades.
Note: Tighten blade attachment screws twice
a year.
9. Light Kit Assembly (Optional).
If you wish to use your fan WITH the light kit,
remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in center of fitter
plate with loosened screws in motor plate,
allowing female plug from motor housing to
come through hole in middle of fitter plate.
Twist fitter plate to lock. Re-insert screw that
was just removed and securely tighten all
3 screws with a Phillips screwdriver.
["Light Kit Assembly" continued on next
page.]
motor
housing
motor plate
page 7
blade attachment
screws and washers
blade
blade arm
(pre-attached)
fitter
plate
female plug