Troy-Bilt 2690XP Manual Del Operador página 20

Ocultar thumbs Ver también para 2690XP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.
Carefully pivot the snow thrower up and forward so that it
rests on the auger housing.
6.
Remove the frame cover from the underside of the snow
thrower by removing the self-tapping screws (a) which
secure it. See Figure 7-4.
(a)
7.
Loosen and remove the shoulder bolt (a) which acts as a
belt keeper. See Figure 7-5.
(a)
7.
Remove the belt from around the auger pulley, and slip the
belt between the support bracket and the auger pulley.
See Figure 7-6.
NOTE: Engaging the auger control will ease removal and
reinstallation of the belt.
20
S
7— S
ection
ervice
(a)
(a)
(a)
Figure 7-4
Figure 7-5
Figure 7-6
8.
Replace the auger belt by following instructions in reverse
order.
NOTE: Do not forget to reinstall the shoulder bolt and
reconnect the spring to the frame after installing a
replacement auger belt.
9.
After replacing the auger belt, perform the Auger Control
Lever test on page 1011 to verify the belt is adjusted
correctly.
Drive Belt
NOTE: See an authorized Service Dealer to have the drive belt
replaced or phone Customer Support as instructed on page 2 for
assistance.
Friction Wheel Inspection
If the snow thrower fails to drive with the drive control engaged,
and performing the drive control cable adjustment fails to
correct the problem, the friction wheel may need to be replaced.
NOTE: Special tools are required and several components must
be removed in order to replace the snow thrower's friction wheel
rubber. See an authorized Service Dealer to have the friction
wheel rubber replaced or phone Customer Support as instructed
on page 2 for assistance.
To inspect the friction wheel, proceed as follows:
1.
Allow the engine to run until it is out of fuel. Do not
attempt to pour fuel from the engine.
2.
Carefully pivot the snow thrower up and forward so that it
rests on the auger housing.
3.
Remove the frame cover from the underside of the snow
thrower by removing four self-tapping screws which secure
it. Refer to Figure 7-4.
4.
Examine the friction wheel for signs of wear or cracking.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Storm tracker 2690xp

Tabla de contenido