Troy-Bilt 2690XP Manual Del Operador página 8

Chute Assembly
1. Remove cotter pin (a), wing nut (b) and hex screw (c) from
chute control head. Remove clevis pin (d) and bow-tie
cotter pin (e) from chute support bracket. See Figure 3-3.
(c)
(a)
2. Insert the round end of the chute control rod into the chute
control head. Push rod as far into chute control head as
possible, keeping the holes in the rod pointing upward. See
Figure 3-4.
8 S 3— A
ection SSembly
(d)
(e)
(b)
Figure 3-3
Figure 3-4
& S -U
et p
3. Place chute onto chute base and ensure chute control rod
is positioned under the handle panel. Secure chute control
head to chute support bracket with clevis pin (d) and
bow-tie cotter pin (e) removed in step 1. See Figure 3-5.
(d)
Figure 3-5
4. Finish securing chute control head by installing
hex screw (c) and wing nut (b). See Figure 3-6.
(c)
Figure 3-6
(e)
(b)