Yakima Viper Manual De Instalación página 2

Install tray bolt, wheel strap and end cap.
short bikes or wide crossbar
spreads may require the strap to
go on before the bolt.
(Large bikes, or short crossbar spreads)
Decide where
you will position
the Viper along
your crossbars.
Secure opposite end.
Do you have
round or square
crossbars?
IF ROUND, continue to
• Press open the
red cover.
• Pull silver hook
outward until bottom
plate opens.
1033576B-2/15
Insert bolt head
into slot in tray.
BETWEEN THE TOWERS
Viper can slide along the bar for
easy repositioning, even when
locked and loaded.
If you have
SqUARE BARS,
loosen the tabs
by bending them
repeatedly.
Install the wheel strap with
the red button toward you.
(The strap may need to go on first
depending on the bike-to-bar fit.)
Remove the tabs with
scissors or pliers.
Set opened Viper onto the crossbars.
allow the cover to remain
open on the bar.
Attach the tray cap.
Lift the tab while
pushing.
Push until the tab
goes into the hole.
OUTSIDE THE TOWERS
Viper can be in a fixed location
for optimum security when
mounted outside the towers.
Attach
SnapAround
to opposite
bar.
Align the bolt to the
SnapAround and insert
into the square hole.