Important Safety Instructions; Technical Specifications - Truper CARBA-200X Instructivo

CONTENTS
Technical data ...............................................................................................

Important Safety Instructions ..................................................................

Personal Safety Cautions............................................................................
Preparation to charge .................................................................................
Charger Location ..........................................................................................
Connection Precautions in c.c. connection ..........................................
Follow these steps when the battery is set in the vehicle ..............
Follow these steps when the battery is set out of the
vehiclevehículo .............................................................................................
Ground Connections and a.c. power .......................................................
Mounting Instructions .................................................................................
Control Panel .................................................................................................
Operation Instructions ...............................................................................
Maintenance and Care ................................................................................
Troubleshooting ............................................................................................
Warranty Policy and Authorized Service Centers ...............................

TECHNICAL SPECIFICATIONS

Input
Voltage: 127 V~
Frequency: 60 Hz
Current: 0,29 A - 19,1 A
Output
Voltage: 12 V
Impulse: 40 A
Maintenance Load: 2 A - 6 A
Motor kickoff: 200 A
5 seconds ON
180 seconds OFF
Work Cycle: Maximum 5 cycles
Transformer insulation Class: Class "H"
Insulation cable cord grips type: "Y"
All conductors are: 18 AWG x 3 C with 221 ºF insulation
temperature
IMPORTANT NOTE: Avoid the risk of electric shock or severe
injury. When the power cable gets damaged it should only be
replaced by the manufacturer or at a Truper
Center. Power grips used in this product is type "Y"
The build quality of the electric insulation is altered if while in
use splashing or liquid get into the tool. Do not expose to rain,
liquids and / or dampness.
WARNING
Before gaining access to the terminals all
power sources should be disconnected.
This device is built with overload protection through a thermal
fuse that turn ON the electricity is OFF
This symbol indicates this equipment
is in compliance with the Official Mexican
Standard (NOM)
2
IMPORTANT SAFETY INSTRUCTIONS
1. Keep these instructions. This Manual content are important
2
2
2. This charger is not meant to be used by children.
3
3. Do not expose the charger to rain or snow.
3
4. Using an accessory not recommended or supplied by the
3
3
4
5. To reduce the risk of damaging the plug or power cable, pull
4
4
6. You shall not use an extension cable unless strictly
5
5
5
7
8
9
7. Do not use the charger if the power cord is damaged; replace
8. Do not use the charger if it received a strong bump, it fell or
9. Do not disassemble the charger. Ask a trained person to
10. To reduce the risk of electric shock, disconnect the charger
a) It is risky working near a lead battery. Batteries generate
Authorized Service
®
b) To reduce the risk of the battery exploiting, follow these
operative and safety instructions.
battery charger manufacturer is a risk of fire, electric shock
or personal injury.
the plug instead of the cable when disconnecting the
charger.
necessary. Using an extension that is not adequate may
start a fire or electric shock. In the event of needing to use
an extension cable make sure that:
• The pins in the extension cable plug are the same number,
size and shape as the ones in the charger plug.
• The extension shall be correctly connected and in good
electric conditions.
• The cable size shall be wide enough for the alternate
current of the charger as specified in the Ground
connections and alternate energy current (page 3)
the power cord at a Truper Authorized Service Center
is damaged in any way. Only certified personnel shall check
it at a Truper Authorized Service Center
check at a Truper Authorized Service Center. If you assemble
it back it may cause fire or electric shock.
from the power supply before carrying out maintenance or
cleaning service. Turning OFF the controls DOES NOT reduce
those risks.
WARNING
RISK OF EXPLOSIVE GASSES.
explosive gasses during the normal functioning. Therefore, it
is very important to follow the instructions each time you
use the charger,
instructions and the manufacturer instructions of any
equipment you will be using near the battery. Check the
caution measures in this product and the motor.