Truper CARBA-200X Instructivo página 18

TROUBLESHOOTING
PROBLEM
• The charger is no ON even
when is well connected.
• No start when starting the
motor.
• The red LED is illuminated.
8
POSSIBLE CAUSE
• Alternate current socket is not
functioning
• Inadequate power connection
• Defective battery
• Consumption higher than 200 A
• It does not wait 3 minutes (180
seconds) between startups.
• The charger might be in reheating
status
• The battery might be severely
discharged.
• The voltage in the battery is still
below 10 V after 2 hours
charging
• In maintenance mode, the output
current is more than 1,5 A during
12 hours.
• The battery cannot be
desulphurated
• Progress fault is detected and the
battery tension is below 14,2 V
• The initial voltage of the battery is
below 12,2 V and the total input
es lower than 1,5 Ah.
• The battery voltage falls below
12,2 V in the maintenance mode.
SOLUTION
• Control the possible presence of open fuses
or disruptors supplying energy to the
alternate current socket.
• Control the possible loss of the plug
belonging to the power cables or electric
extension
• Send the battery to be checked
• The startup time varies, regarding the
amount of energy consumed. If the startup
consumes more than 200 A, the starting
time cod be lower than 5 seconds.
• When the motor startup LED is blinking, wait
3 minutes rest before the next startup.
• The thermal protector might be
disconnected and needs a higher rest time.
Make sure the charger fans are not blocked.
Wait one more minute and try again.
• If the battery has very low charge, use the
boost adjustment 10 to 15 minutes to
assist in the startup.
• The battery might be defective. Verify or
replace.
• The battery might be defective. Verify or
replace.
• The battery may overheat. If so, allow it to
cool down. The battery might be too big or
have a short circuit. Verify or replace.
• The battery capacity is too low or the
battery is too old. Verify or replace.
• The battery is not keeping the charge. It
might be caused by a discharged battery or
a bad battery. The battery might be
defective. Double check there are not loads
in the battery. If so, eliminate. If none,
verify or replace the battery.