Truper CARBA-200X Instructivo página 15

MOUNTING INSTRUCTIONS
Untangle all the wires and extend the cables before using the
battery charger.
Pull up the handle from the retracted position pulling upwards
until clicking in place (Push in the small silver buttons if
necessary)
CONTROL PANEL
• ON / OFF SWITCH
Use this switch to select between the charge speed / keep, drive
speed and start mode of the motor.
OFF - When the switch is in this position (in the center) the
charger is OFF.
• BOOST or CHARGE / MAINTENANCE
When the switch is in this position, the charge selector button
can be adjusted to 6 A <> 2 A charge / maintenance or the 40 A
impulse configuration.
• MOTOR START
When the switch is in this position, the LED light for motor start
will activate and will be constantly kept when connected to the
battery.
• CHARGE SELECTION
Use this button to establish the following selections.
• 6 A <> 2 A CHARGE / MAINTENANCE
For small and large batteries. It is not recommended for
industrial applications.
• 40 A BOOST
For a fast incorporation of energy to a discharged battery or big
capacity battery before starting the motor.
• 200 A MOTOR START
Delivers 200 A to start a motor with a weak or empty battery.
always use it in combination with a battery
LED INDICATORS
• LED inverted clamps / defective battery (Red LED
blinking)
The connections are reversed.
• LED inverted clamps / defective battery (Red LED
stays ON)
The charger is detecting a problem with the battery. See
Troubleshooting to learn more
• LED (YELLOW / ORANGE) ON:
The charger is connected and the battery is being "fed"
• LED Charging / Maintenance (GREEN) ON:
The battery charge is complete, the charger switched to
maintenance mode
NOTE: See the Operation instructions to learn about a complete
description of charger modes.
OPERATION INSTRUCTIONS
Provoking a spark near the battery may cause an
WARNING
explosion.
CHARGING THE BATTERY IN THE VEHICLE
1. Turn OFF all the accessories in the vehicle.
2. Keep the hood open.
3. Clean the battery terminals.
4. Set the switch into the OFF position
5. Set the alternate current cables / continuous current cables
away from the fan blades, bands, pulleys and other mobile
parts that could cause injuries.
6. Connect the battery following the instructions indicated in
the "Follow these steps when the battery is set inside the
vehicle" section in page 4.
7. Connect the charger into the power supply.
8. Having the charges plugged and connected to the vehicle
battery, set the switch into the
Charge / Maintenance position
9. Select the desired speed.
10. When unplugging the charger, adjust the switch into the OFF
position. Disconnect the charger from the alternate current.
Disconnect the clamp from the vehicle chassis and remove
the clamp off the battery terminal.
CHARGING THE BATTERY OUT OF THE VEHICLE
1. Set the battery in a well-ventilated area.
2. Adjust the switch into the OFF position
3. Clean the battery terminals.
4. Connect the battery following the instructions indicated in
the "Follow these steps when the battery is out of the
vehicle" section in page 4.
5. Connect the charger to the power supply.
6. Having the charger plugged in and connected to the vehicle
battery, set the switch into the
Charge / Maintenance position
7. Select the desired speed.
8. When disconnecting the charger, adjust the switch into the
OFF position. Disconnect the charger off the vehicle and
remove the clamp from the battery terminal.
9. A marine (boats battery shall be removed and charge on
ground.)
Boost or
Boost or
5