Fan Operation; Maintenance And Care - Truper CARBA-200X Instructivo

COMPLETING THE CHARGE
Completing the charge is indicated with
(GREEN).
When the charger is ON it has passed from the function mode to
the maintenance mode.
MAINTENANCE MODE (FLOATING MODE MONITORING)
When the LED charging / maintenance (GREEN) light is
ON, it means it has passed to the maintenance mode. In this
mode the charger keeps the battery totally charged through a
small current when it corresponds. If the charger has to
function to the maximum in continuous current of maintenance,
during a 12-hour period, it will change into the interrupting
mode (see Override charge). This is occasionally caused by a
loss of energy in the battery or the battery is damaged. Make
sure the battery is not leaking charge and if so, prevent it,
otherwise, verify or replace the battery.
MAINTAINING A BATTERY
The CARBA – 200X charge and maintain 12 V batteries keeping
a full charge.
NOTE: Technology in maintenance mode allow to charge safely
and keep a battery in good repair during long periods of time.
Mow, problems with the battery, electric problems in the
vehicle, wrong connections or other condition that may arise,
could cause absorption of excessive current. So, occasionally,
follow up your battery performance and the charge process
required.

FAN OPERATION

LED charging It is normal for a fan to operate continuously. Keep the area
near the charger with no obstructions to allow the fan to work
correctly.

MAINTENANCE AND CARE

You can maintain your charger with minimum care and have it
functioning correctly many years.
• Clean the clamps each time you finish using the charger.
• Every now and then, clean the charger housing with a soft
• Roll carefully the input and output cables when storing the
• Store the charger unplugged from the alternate current
• Store indoors in a fresh and dry place. Do not store the
Clean the battery fluid that could have been in contact with
the clamps to prevent corrosion.
cloth to keep the shiny finish and prevent corrosion.
charger. This will help to prevent accidental damage to the
cables and the charger.
power supply and in a vertical position.
clamps in the handle joined with a clip in / or around the
metal or fasten the cables.
7