Truper CARBA-200X Instructivo página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BOOST MODE
NOTE: The unit will change automatically to the
mode, depending on the voltage. To select the
maintenance mode, press the
To select the boost mode, press the
button until the LED light is yellow / orange to
40 A is lit
The light
LED will light up if the battery is connected
correctly and the boost process will start.
NOTE: The boost mode will remain energized until pulsing the
charge selection button or until the ON / OFF main switch
is in the OFF position
CHARGE / MAINTENANCE MODE
To select this mode, press the
until the yellow / orange 6 <> 2 A LED light for
maintenance is ON.
The
LED light will illuminate if the battery is correctly
connected; then, the charging process will start.
When the battery is completely charged, the green LED light for
charging / maintenance will illuminate. If the charge
cannot be completed, the LED light reversed clamps / defective
battery
(RED) will illuminate. The battery may be in bad
repair. Check it.
NOTE: If the battery voltage is lower than 12,7 V , the charger
will automatically enter the boost mode to add in a fast manner,
energy to the battery. To abort / avoid temporary increase and
force the charger in the
charge selection button again (while boost continues).
USING THE START MOTOR FUNCTION
The battery charger can be used to boost the automobile if the
battery is low. Follow all instructions and safety caution
measures in charging the battery.
Wear full eye protection and protective clothes.
WARNING
Using the motor start function in the motor
when the battery is not installed in the vehicle will damage the
electric system.
NOTE:In extreme cold weather or if the battery is smaller than
2 V, boost the battery during 5 minutes before starting the
motor.
NOTE: If you have already charged the battery and the vehicle
still is not starting, do not use the motor start fuction. It will
damage the electric system in the vehicle. Have the battery
checked.
1. Set the selector into the OFF position.
2. Unplug the charger from the alternate current power supply.
Connect the charger to the battery following the instructions
in "charging the battery in the vehicle" section
3. Connect the charger alternate current power cable to the
alternate current power supply.
4. Having the charger connected to the vehicle battery, adjust
the ON / OFF switch into the
6
boost
charge /
charge selection button.
charge selection
boost to
charge selection button
charge /
charge selection mode, press the
motor start position.
5. Start the motor until it starts running or after 5 seconds. If
the motor is not starting, wait a few minutes before trying
again. This will cool down the charger and battery.
NOTE: After 3 minutes in the start motor mode, the charger will
enter a 180 seconds cooling period. The yellow / orange LED of
motor start will blink during the cooling period.
6. If the motor is not starting, use the adjust 40 A
during 5 minutes before starting again.
7. After the motor is running, turn the selector into the OFF
position and disconnect the power cable from the alternate
power supply before disconnecting the clamps from the
vehicle battery.
8. Clean and store the charger in a dry place.
NOTE: If the motor rotates but is not ON, there is no problem
with the starting system, but in any other part of the vehicle.
STOP starting the motor until the problem is diagnosed and
corrected.
CHARGING TIMES
BATTERY
APPLICATION
SIZE
Powersports
6 Ah
32 Ah
Automotive
300 CCA
1 000 CCA
Marine
50 Ah
105 Ah
These times are based in a battery 50% discharged and may
change depending of the age and condition of the battery.
OVERRIDE CHARGE
If the charge cannot be completed normally, the charge will
override. When the charge is interrupted, the charger output is
OFF and the LED inverted clamps
not continue trying to charge this battery. Check the battery
and replace if necessary
DESULPHURIZATION MODE
Desulphurization can take 8 to 10 hours. If desulphurization fails,
the charge will be aborted and the LED inverted clamp
will illuminate.
boost
CHARGING TIME (HOURS)
2 A
6 A
8 A
10 A
6
2
1,75
1,5
15
5
4,5
4
12
4
3,5
3
30
10
8,5
7
15
5
4,25
3,5
33
11
9,5
8
(RED) will illuminate. Do
(RED)

Publicidad

Tabla de contenido
loading

Tabla de contenido