Available Accessories - Shark Navigator Pet ZU60 Serie Guia Del Usuario

AVAILABLE ACCESSORIES

Duster Crevice Tool
A
Two cleaning tools in one. The crevice tool
gives you extended cleaning reach for small
spaces, while the soft dusting brush cleans
a multitude of surfaces.
Wide Upholstery Tool
B
The wide cleaning path helps remove pet
hair, dust, and large debris from mattresses,
couches, curtains, lampshades, and other
delicate upholstered surfaces.
Hair Removal Multi-Tool
C
A single convertible tool for cleaning
tough pet messes two ways: Use the stiff
bristle brush to remove stubborn hair from
carpets, or take off the bristles to reveal
an upholstery tool perfect for cleaning
couches and bedding.
Pet Power Brush
D
Designed to remove pet hair and ground-in
dirt from carpeted stairs and upholstery.
Under-Appliance Wand
E
Clean under and behind hard-to-move
appliances and furniture with this adjustable
36" tool. Flip the extension piece over to
clean the underside of appliances.
NOTE: Not all accessories come with all units. Please see the enclosed Quick Start Guide for your unit's
configuration. To order additional accessories, visit sharkaccessories.com.
s h a r kc l e a n . c o m
Vacuum is not picking up debris. No suction or light suction.
A
• Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinserting in the vacuum.
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
blockages found.
(Refer to Checking for Blockages section for more information.)
• If any string, carpet fibers, or hair is wrapped around the brushroll, extend cleaning time to
allow the self-cleaning brushroll to remove it.
– If some hair or fibers remain wrapped around brushroll after continued use, remove the
floor nozzle cover and carefully cut debris with scissors and remove from brushroll. See
B
Cleaning the Brushroll section for more information.
Vacuum lifts area rugs.
• Make sure Power/Surface switch is set to Hard Floor (setting I).
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn
edges.
Brushroll does not spin in carpet cleaning mode.
• If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum.
Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum,
C
and turn on power.
• With the power on, recline the handle, which will automatically turn on the brushroll.
• Ensure that the Power/Surface switch is set to Carpet (setting II) for brushroll
to spin.
Vacuum turns off on its own or indicator light flashes red.
This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the
thermostat will automatically turn the suction motor off. Perform the following steps to restart
the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning and
Replacing the Filters.).
D
3. Check for blockages in hose, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 45 minutes.
5. Plug in vacuum and turn it on.
E
For all other issues, please call Customer Service 1-800-798-7398.
TROUBLESHOOTING
s h a r kc l e a n . c o m