Available Accessories - Shark APEX DuoClean AZ1000 Serie Guia Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AVAILABLE ACCESSORIES

Crevice Tool
A
This slender tool offers extended reach to
access corners, baseboards, tight spaces,
and ceilings.
Upholstery Tool
B
Picks up hair, dust, and large debris from
mattresses, couches, curtains, lampshades,
and other delicate upholstered fabrics.
Pet Multi-Tool
C
A single convertible tool for cleaning tough
pet messes two ways: use the stiff bristle
brush to clean stuck-on debris, or take off
the bristles to reveal an upholstery tool
perfect for removing stubborn pet hair and
large piles of debris.
Duster Crevice Tool
D
Two cleaning tools in one. The crevice tool
gives you extended reach to clean in tight
spaces, while the soft brush is ideal for
dusting delicate surfaces.
Pet Power Brush
E
The turbine brush loosens and removes
pet hair and debris from carpets, and
powerfully deep-cleans dander out of
upholstery and other surfaces.
Under-Appliance Wand
F
Clean under and behind hard-to-move
appliances and furniture with this adjustable
36" tool. Flip the extension piece over to
clean the underside of appliances.
Anti-Allergen Dust Brush
G
This brush features nylon fiber bristles
specifically designed for removing fine
dust and allergen particles from the most
delicate surfaces.
Self-Cleaning Pet Power Brush
H
Tackles pet hair and ground-in dirt from
above-floor areas like carpeted stairs and
upholstery, while actively removing hair
wrap as it cleans.
Home & Car Detail Kit
I
Deep-clean your car like a professional
detailer, or clean hard-to-reach areas in
your home. Micro-sized tools let you clean
around delicate objects and access the
tightest spaces like car vents and computer
keyboards.
Accessory Bag
J
This convenient accessory storage bag
measures 32 cm x 70 cm and fits the Under-
Appliance Wand. Smaller size available at
sharkaccessories.com.
NOTE: Not all accessories come with all units. For a list of the accessories included with this model, see the top inside flap
of the box. To order additional accessories, visit sharkaccessories.com.
s h a r kc l e a n . c o m
A
B
C
D
E
F
G
H
I
J
TROUBLESHOOTING
Vacuum is not picking up debris. No suction or light suction.
• Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinstalling them.
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
blockages found.
(Refer to Checking for Blockages section for more information.)
• If any hair, string, or carpet fibers are wrapped around the brushroll, extend cleaning time to
allow the self-cleaning brushroll to remove them.
– If some hair or fibers remain wrapped around brushroll after continued use, take off the
brushroll garage lid and carefully remove them. See Cleaning the Brushroll section for
more information.
Vacuum lifts area rugs.
• Make sure Surface Selector switch is set to Hard Floor.
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges.
Brushrolls do not spin.
• If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum.
Remove pod and wand from floor nozzle and clear any blockages. Reconnect nozzle, plug in
vacuum, and turn on power.
• With the power on, recline the handle, which will automatically turn on the brushrolls.
• If the brushroll indicator light is green and the headlights are flashing, the brushroll garage
lid is not properly installed. Remove the lid by sliding the two release buttons on the floor
nozzle. To reinstall, insert the 3 tabs into the 3 slots in the nozzle, then firmly push down on
both sides of the lid until it clicks securely into place.
Vacuum turns off on its own or indicator light flashes red.
If your vacuum overheats, the thermostat will automatically turn off the motor. Perform the
following steps to restart:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning the Filters).
3. Check for blockages in hose, wand, floor nozzle, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 60 minutes.
5. Plug in vacuum and turn it on.
For all other issues, please call Customer Service 1-800-798-7398.
s h a r kc l e a n . c o m

Publicidad

Tabla de contenido
loading

Tabla de contenido