Safety Notes; Functions; General Notes - Trix E 19.01 Serie Manual De Instrucciones

Safety Notes

• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
GB

Functions

• This model is designed for operation with H0 2-rail
DC systems (track according to NEM standards) with
conventional DC power packs.
• Analog 14 volts DC, digital 22 volts AC.
• The minimum usable radius is 420 mm.
• Functions in conjunction with the decoder:
Headlights
• This locomotive comes equipped with a Trix connector
for digital operation and can have the Trix locomotive
decoder 66839/66849 installed in it.
• Trix motor vehicles must not be operated on digital
systems without an built-in engine decoder (Motor can
be damaged!).

General Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
7