Driving And Removing Screws - Hilti SD 4500-A22 Manual Del Usuario

5.3 Fitting the belt hook in the alternative position
1. Press both battery release buttons simultaneously and pull the battery out of the screwdriver.
2. Unscrew both belt hook retaining screws.
3. Bring the belt hook and threaded piece into place on the other side of the tool.
4. Reinsert and tighten the two retaining screws.
5.4 Working safely with the belt hook and universal hook
▶ Before beginning work, make sure that the belt hook and universal hook are securely attached to the
screwdriver.
▶ Use the universal hook only when necessary. Lay the screwdriver down in a safe place when it is not in
use for a long period.
5.5 Forward / reverse 4
Note
The control switch is locked when the forward / reverse switch is in the middle position (safety lock).
▶ Set the forward / reverse selector switch to forward or reverse rotation.
5.6 Changing the accessory tool.
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Push the chuck towards the screwdriver, turning the chuck slightly at the same time, and then hold it in
this position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool in the chuck, pushing it into the screwdriver as far as it will go.
5.7 Removing the battery
▶ Press both battery release buttons simultaneously and pull the battery out of the screwdriver.

6 Driving and removing screws

6.1 Driving screws 7
WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into a concealed electric cable
and, at the same time, the bit holder or depth gauge is touched.
▶ Hold the screwdriver only by the grip when driving or removing screws.
1. Set the screwdriver to forward rotation.
2. Check that the battery is in the working position.
3. Position the screw on the bit and bring the tip of the screw into contact with the working surface.
4. Use the control switch to regulate the speed of the screwdriver.
6.2 Removing screws
1. Pull the depth gauge off.
2. Set the screwdriver to reverse rotation.
3. Insert the bit in the head of the screw and use the control switch to regulate the speed of the screwdriver.
4. Refit the depth gauge after removing the screws.
6.3 Switching on in sustained operating mode
▶ Switch on in sustained operating mode.
6.4 Switching off after sustained operation
▶ Press the control switch.
◁ The lockbutton returns to its original position.
6
Printed: 11.08.2016 | Doc-Nr: PUB / 5295856 / 000 / 00
5
6
8
3