Fitting The Accessory Tool; Removing The Accessory Tool - Hilti SBT 4-A22 Manual Del Usuario

All manuals and user guides at all-guides.com
5.1.1 Inserting the battery
CAUTION
Risk of injury. The drill/driver may start inadvertently.
▶ Before fitting the battery, check that the drill/driver is switched off and that the switch safety lock
is activated.
CAUTION
Electrical hazard. Dirty contacts may cause a short circuit.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts in the
drill/driver are free from foreign objects.
CAUTION
Risk of injury. If the battery is not fitted correctly it may drop out and fall.
▶ Check that the battery is securely seated in the tool so that it cannot drop out and fall, thereby
presenting a hazard to other persons.
▶ Push the battery into the tool from the rear until it engages with an audible click.
5.1.2 Removing the battery
▶ Remove the battery.
5.1.3 Fitting and adjusting the side handle
CAUTION
Risk of injury. The drill/driver may start inadvertently.
▶ Make sure that the forward / reverse switch is in the middle position (safety lock engaged) or that
the battery has been removed from the drill / driver.
▶ Fit or adjust the side handle.

5.1.4 Fitting the accessory tool

1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
5. Check that the accessory tool is held securely.

5.1.5 Removing the accessory tool

1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Open the keyless chuck.
3. Pull the accessory tool out of the keyless chuck.
5.1.6 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself and others.
▶ Check that the belt hook is fitted securely before beginning work.
Note
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
Printed: 09.06.2017 | Doc-Nr: PUB / 5356273 / 000 / 00
2
3
4
5
English 15