Black and Decker CS1015 Manual Del Usuario página 7

OveRvIeW (fIg. 5)
1. On/off switch
2. Main handle
3. Secondary handle
4. Shoe
5. Saw blade
6. Saw blade lower guard
7. Lower guard retracting lever
8. Saw blade spanner wrench
9. Bevel adjustment knob
10. Outer blade clamp washer
11. Blade retaining bolt
12. Depth adjustment lever
13. Depth scale
14. Bevel angle scale
15. Saw blade hex wrench
5
1
2
7
8
4
10
6
ASSeMBLy / ADjUSTMeNT SeT-P
WARNINg: Always unplug saw from
power supply before any of the following
operations.
ADjUSTING ThE DEPTh OF CUT (FIG. 6 & 7)
The depth of cut should be set according
to the thickness of the workpiece.
• Loosen the lever (12) to unlock the saw
shoe.
• Move the saw shoe (4) into the desired
position. The corresponding depth of
cut can be read from the scale (13).
• Tighten the lever to lock the saw shoe
in place.
• Set depth adjustment of saw such that
one tooth of the blade projects below
the workpiece as shown in figure 7.
ADjUSTINg The BeveL ANgLe (fIg. 8)
This tool can be set to bevel angles
between 0° and 45°.
3
9
5
11
7
6
7
Surface of wood
• Loosen the locking knob (9) to unlock
the saw shoe.
• Move the saw shoe (4) into the desired
position. The corresponding bevel
angle can be read from the scale (14).
• Tighten the locking knob to lock the
saw shoe in place.
8
9
ATTAChINg The BLADe (fIg. 9 & 10)
• To prevent spindle rotation engage the
protrusions of the spanner wench (8)
into the holes in the outer washer (10)
as shown in figure 9.
• Loosen and remove the blade
retaining screw (11) by turning the hex
wrench (15) counter- clockwise.
• Remove the outer washer.
• Place the saw blade (5) onto the
spindle shaft, (16), making sure that
the arrow on the blade points in the
same direction as the arrow on the upper
gaurd of the tool.
• Fit the outer washer (10) on the spindle with
the larger flat surface against the blade.
• Insert the blade retaining screw (11)
into the hole in the spindle.
13
12
Tip of tooth
14