Publicidad
SLIDING DOOR HARDWARE-BARN DOOR
ROUND TRACK, TOP MOUNT
1
CARRIER INSTALLATION
• Locate center of carriers 6-8" from each vertical edge of door.
• Using a square, locate carriers at the center of the door width.
NOTE: It is critical carriers are square and centered on door width
to achieve proper carrier/track interaction.
• Mark mounting hole locations using the carriers as a guide.
• Drill pilot holes at mounting hole locations using 1/16" drill bit.
Mount carriers with provided screws.
2
RAIL INSTALLATION
• Track height = door height + desired floor gap and carrier. Gap = 3/32"
• Track is designed to be secured on 16" centers or less (to line up with wood or steel
framing structures) and within 6" of each end. For walls with greater spacing between
structural members, additional structure must be provided to achieve the required fastener
spacing.
• Lay out the location of the rail on the wall at the proper height. Find the locations of the
structural wall framing members or solid anchor points and slide brackets onto track at the
proper spacing. If the mounting locations do not meet the above requirements, additional
structure must be provided to achieve the required fastener spacing.
• A shim board might be required to space track from wall to clear base or door molding and
to provide a flat surface to mount track.
• Drill pilot holes for mounting fasteners using a 1/8" bit through the brackets at the proper
locations.
• Secure the track to the wall through the predrilled holes into the structural wall members
using provided fasteners.
3
END STOPS AND CENTER GUIDE INSTALLATION
(FLOOR-MOUNTED AND WALL-MOUNTED)
• Install the door on the track by sliding on end. If space does not allow for this then
door must be tilted out and carriers placed on track until door can be swung down
to proper position.
• After installing the door onto the track, slide the door to the desired open position.
• Install the END STOP bracket to the floor or wall so that the door stops in the
desired OPEN position.
• Install the CENTER GUIDE bracket on the other end of the door so the door is
always captured by this bracket in the fully opened and fully closed position.
• Slide door to closed position so door is still contained by center guide.
Mount remaining end stop for the closed position.
NOTE: The track must be level in order for door to stay level.
Brackets must be mounted in orientation shown.
#310443 (1015)
Assembly
Instructions
Publicidad
