Operation(Model#Dpfr2190); Loading Fasteners; Unloading Fasteners; Clearing Jams - Husky DPFR2190 Guía De Uso Y Cuidado

Operation(Model#DPFR2190)

1

Loading fasteners

Connect the tool to the air source
.
Insert strip of fasteners from the rear of magazine (A). Be
sure the fasteners are pointed downward.
(See figure 1 & figure 2)
This tool uses a spring loaded bypass lever in order to
load and upload the nails. Once the nails are properly
inserted, pull the pusher (B) completely back, pressing
against the bypass lever of the pusher. (See figure 3)
Once the pusher hits the back of magazine, allow the
pusher to slide forward and engage the nails, pushing
them to the nose of the tool. (See figure 4).
Rear of magazine(A)
Head of nail
INSERT NAIL STRIP
MAXIMUM
LOAD
Nail Hold
Back Spring
Pusher(B)
Press
bypass lever
Figure 1
ENGAGE NAILS
SLIDE FORWARD
WARNING: The tool may fire when it is first connected
to the air source Always connect the tool to the air
.
source before loading fasteners to prevent injury from
unintended cycling Always make sure the tool s
.
magazine is empty at the beginning of each work
Figure 2
session before connecting to an air source
,
WARNING: Use only those fasteners recommended
for use with this tool Fasteners not identified for use
.
with this tool by the tool manufacturer are able to
result in a risk of injury to persons or tool damage
when used in this tool.
WARNING: Keep the tool pointed away from yourself
and others when loading fasteners Failure to do so
could result in possible serious personal injury
WARNING: Never load fasteners with the workpiece
contact or trigger activated Doing so could result in
possible serious personal injury
10
Operation(Continued)-(Model#DPFR2190)
2
Figure 3

Unloading fasteners

Disconnect the tool from air source.
Pull back the pusher, pressing bypass lever of the pusher
to allow pusher to bypass nails and slowly allow pusher
to return to nose of the tool. (See figure 5)
Slide the fastener to the rear magazine. Once the nails
have slid back to the hold back spring, press the tab on
the hold back spring to push the spring back and allow
the nails to come out of the magazine. (See figure 6)
Figure 4
RELEASE
NAILS
'
.
WARNING: Always unload all fasteners before
removing tool from service.
.
.
WARNING: Always disconnect the air source before
unloading.
.
.
3
Occasionally a fastener may become jammed in the firing
mechanism of the tool making the tool inoperable To
remove a jammed fastener follow the steps below
Disconnect the tool from air source
Remove fasteners from the tool Failure to do so will
cause the fasteners to eject from the front of the tool
Pull the jammed fastener out from the nose use pliers or
a screwdriver if required to clear the jammed fastener
Using caution not to bend or damage the driver blade
Reconnect the tool to the air source
Press
Reload the tool with fasteners
Figure 5
bypass lever
SLIDE FORWARD
Figure 6
PRESS the nail hold back spring
11

Clearing jams

,
, .
, :
.
.
.
,
.
.
.
WARNING: Make sure there is no fastener in magazine
before clearing a jam.
WARNING: Disconnect the tool from the air source
whenever clearing a jam After disconnecting the tool
.
from the air compressor there should still be enough
,
air pressure to fire the tool After the air hose is
.
disconnected always fire the tool into scrap wood
,
repeatedly to make sure all of the compressed air is
expended
.
HUSKYTOOLS.COM
Please contact 1-888-HD-HUSKY for further assistance.
.