HQ-Power STUDIO BEAM 150 Manual Del Usuario página 6

You can use the same starting address for a whole group of devices or enter an individual one
for every device.
When using one single address, all the units will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set different addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
In the case of the 6-channel VDP150MH6, you will have to set the start address of the first
device to 1, the second unit to 7 (6 + 1), the third to 13 (7 + 6), and so on.
e) Selecting the Function
Use the three push buttons and the display to set the various functions. When you turn on the
device, the display setting will be the same as when you turned it off.
Procedure:
• Hold ENTER for 3 seconds until the display starts to flash
• Select a different function with UP
• Press ENTER to confirm the selected function or press EXIT/DN to cancel
• The abbreviation of the active function will flash. Activate or deactivate it with the UP or
EXIT/DN button.
• Press ENTER again to confirm your settings.
• Press EXIT/DN to save the settings and exit the menu.
Please refer to the table below for the different settings :
S/N Function Option Select
Display
0
A - - -
1
RUN
2
FOCU
3
DISP
4
RDIS
5
RPAN
6
RTILT
7
REST
8
INDA
9
LAMP
10
VER
11
TIME
12
TEST
13
CONT
14
EDIT
VDP150MH6
Return to
Main Menu
√
A001...A511
√
ON / OFF
√
ON / OFF
√
DP - X
√
ON / OFF
√
ON / OFF
√
ON / OFF
√
ON / OFF
√
ON / OFF
√
ON / OFF
√
V – 1.0
√
OPEN
√
CLR
√
TE – 1
↓
TE - 16
√
CN – X
SCE1 PAR–1
↓
PAR-N
Display
Set the DMX starting address
AXXX
Runs the program preinstalled in the
RUN
EEPROM.
Focus, open the shutter, select white light
Display the DMX value per channel
DXXX
Reverse display
Reverse pan
Reverse tilt
Reset
Install software into the EEPROM
Lamp ON/OFF control
Software version
Activation duration (for future versions of this
XXXX
device)
Reset lamp working duration (when inserting
a new lamp)
Test the function of each channel
Edit a scene without controller
11 XX
↓
1N XX
6
Explanation
VELLEMAN