Existing Construction Assembly Instructions - Utilitech 7113-01-L Manual De Instrucciones

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS

9. Install a circular duct (not included) and secure it
with duct tape or clamps (neither included).
Finish ceiling work. Ceiling hole should be flush
with the edge of the flange. (DO NOT FLUSH
MOUNT TO JOIST. Flange should be flush
with ceiling board.) See dimensions for ceiling
hole on page 5. If joist is present, insert long
wood screws through flange and through ceiling
to secure fan to joist.
10. Attach plug connector to receptacle.
11. Install two (2) GU24, 13 watt bulbs (not included)
(F).
12. Pinch mounting springs on grille (B) and insert
into narrow rectangular slots inside the fan
housing next to the fan motor.
Turn on electricity at breaker box after finishing
installation.
9
6
7
10
10
Lowes.com