Troubleshooting - Weber Q Manual Del Usuario

Ocultar thumbs Ver también para Q:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
Burner burns with a yellow or
orange fl ame, in conjunction
with the smell of gas.
Burners do not light.
-or- Burners have a small
fl ickering fl ame in the HIGH
position. -or- Barbecue
temperature only reaches
250˚ to 300˚ in the HIGH
position.
Burner does not light, or
fl ame is low in HIGH position.
Experiencing fl are-ups:
CAUTION: Do not line the
bottom tray with aluminum
foil.
Burner fl ame pattern is
erratic. Flame is low when
burner is on HIGH. Flames do
not run the whole length of
the burner tube.
Inside of lid appears to be
"peeling." (Resembles paint
peeling.)
If problems cannot be corrected by using these methods, please contact the
Customer Service Representative in your area using the contact information
on our web site. Log onto www.weber.com

TROUBLESHOOTING

CHECK
Inspect Spider / Insect
Screen for possible
obstructions. (Blockage of
holes.)
The excess fl ow safety
device, which is part of
the barbecue to cylinder
connection, may have
activated.
Is LP fuel low or empty?
Is fuel hose bent or kinked?
Does the Left burner light
with a match?
Are you preheating
barbecue in the prescribed
manner?
Is the cooking grate heavily
coated with burned-on
grease?
Is the burner clean?
The lid is cast aluminum,
not paint. It cannot "peel".
What you are seeing is
baked on grease that has
turned to carbon and is
fl aking off. THIS IS NOT A
DEFECT.
Clean Spider / Insect Screen.
(See Section "Annual
Maintenance")
To reset the excess fl ow
safety device turn the burner
control knobs and the cylinder
valve OFF. Disconnect the
adapter from the cylinder.
Turn burner control knob to
HIGH. Wait at least 1 minute.
Turn burner control knob OFF.
Reconnect the adapter to the
cylinder. Turn cylinder valve
on slowly. Refer to "Lighting
Instructions".
Refi ll LP cylinder.
Straighten fuel hose.
If you can light the Left burner
with a match, then check the
Crossover
All burners on high for 10 to
15 minutes for preheating.
Clean thoroughly. (See
Section "Cleaning")
Clean burner. (See Section
"Maintenance".)
Clean thoroughly. (See
Section "Cleaning".)
.
®
31
CURE
®
ignition system.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Q 200Q 220

Tabla de contenido